top of page
Post-023
Apr. 10th, 2022
Machine Settings: feeds, speeds, and tool setup.
Just CAM'ing counter sinks and counter bores as center drills for geometry...

So a project we're currently working on in lab — is building a little rig to press fit the parts of our motor together concentrically. We're not going to touch much on the design or machining of that device in this post (perhaps a later one) but I've been learning a lot about high-tolerance machining from this project. Today we did some setup of three tools in Fusion 360's tool library including calculating feeds and speeds and we wanted to share that because it's somewhat useful. We'll go through the
NOTE: WE ALSO WANT TO VERIFY THIS ON THE MACHINE THAT'S WHY WE ARE DELAYING THIS POST
bottom of page